1 12

Smooth-On

XTC 3D Print Coating Epoxy Kit

XTC 3D Print Coating Epoxy Kit

$34.98 NZD
$34.98 NZD
Sale Sold out
Tax included.
Size

20 in stock

Product Information

Suitability

Not Suitable

XTC-3D® is a protective coating for smoothing and finishing 3D printed parts. It does not melt plastic. Two liquids are mixed together and brushed onto any 3D print. Coating self-levels and wets out uniformly without leaving brush strokes. Working time is 10 minutes and cure time is about 4 hours (depending on mass and temperature). XTC-3D® cures to a hard, impact resistant coating that can be sanded, primed and painted. Adding colors and metal effects is easy.

  • Inexpensive to Use: 1 oz covers 100+ square inches.
  • 90% Time & Labor Savings: XTC-3D® fills in 3D print striations and creates a smooth, high gloss finish. The need to post finish is almost eliminated.

Coat any 3D Print Surface: XTC-3D® can be applied to both SLA and SLS prints. It works with PLA, ABS, Laywoo, Powder Printed Parts and other rigid media. It also can be used to coat EPS, EPDM and urethane foam as well as wood, plaster, fabric, cardboard and paper.

XTC-3D® does not contain VOC's, phthalates or phosphates.

Can also be used 
View full details

Customer Reviews

Based on 11 reviews
91%
(10)
9%
(1)
0%
(0)
0%
(0)
0%
(0)
M
Mark Webster

Good service, fast delivery

M
Martin
Very satisfied

Perfect product for the job & efficient delivery.

D
Dan Luck
Perfect for finishing PLA prints

I bought this to try making board game bits trays smoother and kinder to cardboard/plastic that was getting caught on striations and layer lines. A single coat of this already made such a fantastic difference, but once I did the second the smoothness was like no other.
Highly recommend. Have used about 30ml (final combination vol) to do 2 layers on 5 decent sized trays so even this small bottle is going to last me a while.
Only feedback would be to get more than one sponge brush as it's unlikely anyone would use this whole bottle in one 15minute session.

P
Peter Jones

XTC 3D Print Coating Epoxy Kit

E
Edwin Pibal
Gets the done…. And then some!

I bought a kit to clean up up a 3d printed model i had made, after only one coat the finish is almost perfect ( some run lines ) once cured it sands smooth with some wet 600 grit sand paper.

Definitely wear gloves!!

123